Aquawrap Fast



Quick, strong — Ideal for lower pressure
pipelines and temporary repair of Low Pressure leaking piping systems

Aquawrap® Fast is a low cost composite system for lower pressure piping and pipelines or the temporary repair of low pressure leaking piping systems. It is odorless and solvent-free. Cured Aquawrap® is a very durable, high long term strength material, impervious to fuels, most chemicals and solvents. It permanently bonds to a wide variety of surfaces such as metals, composites, concrete, plastics and wood.

Aquawrap® is ready to apply, right out of the bag and cures by way of a chemical reaction with field-applied water. This offers considerable advantages over conventional cloth-resin systems in that there is no resin measuring, mixing, spreading, solvents, or dripping polymer mess.


PRODUCT PROPERTIES
Working Time: 3 min. at 25°C (77°F) Mix Ratio: No mixing required
Application Temps: 4-93°C (40-200°F) Service Temps: -18 - 121°C (0 - 250°F)
Cure Time: 5 minutes at 25°C (77°F) Full Cure: 30 minutes at 25°C (77°F)
Usual Packaging: Pre-Packaged Rolls Shelf Life: 1 year
Chemical Resistance: Acetone, mek, toluene, gasoline, ethyl alcohol and many others Hardness: 90 Shore D - ASTM D-2240

TEST STD FABRIC
Tensile Strength (warp and fill directions). psi 35,000
Tensile Modulus (warp and fill directions), msi 2.5
Thickness, mils 12
HDT, °F 325
CTE, in/in °F 8.2 e-6
Bond strength to steel with BP-1 Adhesive, psi 1360

SIZES AVAILABLE
ROLL SIZE MAXIMUM PIPE DIAMETER in.
2" x 12' 2"
4" X 12' 4"




AquaWrap Fast Installation Procedure

Step 1
CLEAN AND ABRADE THE JOINT WITH EMERY CLOTH OR A FILE.

Step 2
CLEAN THE AREA TO BE WRAPPED WITH A SUITABLE SOLVENT SUCH AS ACETONE.

Step 3
FILL ANY HOLES AND APPLY FILLER MATERIAL TO RADIUS THE JOINT SO THAT IT IS EASIER TO WRAP.
Step 4
OPEN THE POUCH OF AQUAWRAP AND BEGIN WRAPING THE JOINT.
Step 5
SPRAY THE WRAP WITH WATER AS THE JOINT IS WRAPPED.
Step 6
CONTINUE WRAPPING AND SPRAYING UNTIL THE ROLL IS FINISHED.
Step 7
CONTINUE WRAPPING THE JOINT AROUND BOTH THE MAIN AND STUB PIPE.
Step 8
ALLOW THE WRAP TO CURE.